Prayer Bead Drilling: Why Hole Placement and Edges Matter

9 November 2026
أمبيريا
Prayer Bead Drilling: Why Hole Placement and Edges Matter

A bead may look evenly shaped from the outside, but its drill hole stays in contact with the cord every time the strand moves. The alignment and finish of the hole deserve as much attention as the outside polish.

How does the position of the hole affect the strand?

On a strand designed with matching beads, drilling along a consistent axis helps the beads sit straight. A distinctly off-centre hole can make a bead tilt when you pull the strand gently taut. Some designs use deliberately irregular forms. In those cases, look at how the bead fits the design as a whole.

How do you check the edges of the hole?

Look at both ends of the hole in a close-up. A rough or chipped edge can increase friction on the cord. The cord needs room to move for its thickness and material. A hole that’s especially wide or tight can make the beads move differently from those on a similar strand.

What you noticeHow to check it
One bead tilts among otherwise matching beadsLook at the strand hanging straight.
The cord appears frayed near a holeAsk for a close-up of the contact point or show it to a maker.
The beads are hard to moveCompare the hole dimensions with the cord’s thickness and tension.

When should you replace the cord?

If the cord starts fraying or the knot loosens, have a maker check the cord and the drill-hole edges before restringing. A new cord replaces a worn one, while inspecting the holes helps explain what caused the wear. Photograph the arrangement of beads and spacers before handing over the strand, especially if the colours follow a set order.

Does a wider hole always make a bead move more freely?

Movement depends on the hole size, cord thickness and the way the strand is strung. The beads should slide comfortably while staying aligned.

References