Do you have a ring that already fits the finger you want to wear the new one on? Measure that ring. If you don’t, a ruler and a strip of paper can give you a rough measurement of the finger itself. Keep the size chart handy, since inside diameter and finger circumference belong in different columns.

Two illustrations of the measuring methods. The ruler was digitally added to an Amberia ring photo. In the paper-strip photo, the mark shows where the ends overlap on the ring finger.
Already have a ring? Measure the opening
- Choose a round ring that fits comfortably on the same finger of the same hand. If the new ring has a wide band, try to measure one of similar width.
- Put the ring on a flat surface. Line up the ruler’s zero mark with the inside edge and read the number at the opposite inside edge. Run the ruler through the centre of the opening and leave the metal out of the measurement.
- Rotate the ring a little and measure again. If there is a clear difference, check that the ruler passed through the centre and that the band is round. One diameter is an unreliable guide for an oval or bent band.
- Look up the reading in the inside diameter column. For example, around 19.8 mm corresponds to a US size 10 in the Amberia chart.
No ring to hand? Measure your finger’s circumference
- Cut a narrow strip of paper and wrap it around the base of your finger. Let it sit comfortably against the skin, then mark where the end meets the rest of the strip.
- Check that the loop can pass over the knuckle, then lay the strip flat against a ruler. The distance from the end to the mark is the circumference in millimetres. Measure twice more to make sure you didn’t pull it too tight.
- Match the result to the circumference column. If the knuckle is much wider than the base of the finger, try sizing rings at a jeweller. You can find a size that passes over the knuckle and stays in place.
What if the measurement falls between two sizes?
Write down the number as measured and label it “diameter” or “circumference.” If it’s close to the line between sizes, measure again, especially if your hand was cold or swollen. For a wide band, trying on a ring of similar width is more reliable than guessing.
If you consult a second chart, check the sizing system. “US 10” is a size. “19.8 mm” is a ruler reading. Use the zero mark, since some rulers leave a small gap between the edge and the first mark.
Open the Amberia size chart and use the column that matches what you measured.